Installation Instructions for your Messy Monkey High Chair Slipcover: Once you have unpacked your Messy Monkey High Chair Slipcover you will notice that there are 2 small holes a few inches apart from one another on the printed side of the cover (which is the top) and 1 vertical larger hole and 1 horizontal larger hole near each other (that is the bottom). Standing in front of your high chair, slide the shoulder straps one at a time through the holes that are aligned to those straps. Next, pull the seat straps through the holes on either side of the slipcover which is located in the base of the seat. If your high chair has the center buckle, pull that through the horizontal hole. Pull the vertical hole over the leg divider (some high chairs leg divider is attached to the tray which will hang down from the tray. You will simply skip this part). Next, stretch the top part of the slipcover around the seat back. Depending on the size, depth and width of your chair you may have more or less fabric. At this point pull additional fabric down the backside of the seat back until taut. Then stretch the bottom of the slipcover around the foot rest. Optional, to fold the foot rest up so it is in an upright position or remove the foot rest entirely. Pull the sides of the slipcover around the sides of the padding (not on the high chair tray rest, but between the padding and the high chair). Adjust so the printed fabric is centered with the high chair. Lastly, put tray back onto high chair and Enjoy.
|
